The How to Adjust Zero for Injection Axis guide provides steps for setting the mechanical zero position on the injection axis in Zhafir machines. Begin by installing and adjusting the belt tension to ensure it is neither too loose nor too tight. Then, access the "Zero Setting" page, activate zero setting mode by switching on the "Zero Status" button, and press "Injection Forward" to move the screw to the mechanical zero position. Click the "Zero End" button to confirm the setting, restart the machine, and test the injection movement in adjust mode to verify accuracy. This guide is essential for precise zero calibration on the injection axis.
To adjust the mechanical zero position
Before you start “zero setting”,you should install the belt and adjust the tension of the belt(can not be two loose or too tighten,if you has the other machine with some type you had better to have the feeling of the tension),then following the steps of we list!
1. First, turn to the “zero setting”page as following picture!
2. Swith on the”zero status”button to activate the zero setting mode.
3. Press”Injection forward” button to move the screw to mechanical zero position, then click “zero end”button which refer to the Injection axis.
4. Restart the machine, then try to move the injection by adjust mode to check if it is OK!